OMNIE HOME USB Coordinator – OMNIE Underfloor Heating, Heat Pumps & Ventilation
We - and our partners - use cookies to deliver our services and personalise your experience. By using our website, you agree to the use of cookies as described in our Cookie Policy.
×
Get a Quote
NEW - TorFloor 2
Boiler Upgrade Scheme
Underfloor Heating
Underfloor Heating
Why UFH?
Explore the Range
Floating Floors
Floating Floors
FoilFloat
LowBoard
OMNIE-Tile
Back
Batten Floors
Batten Floors
FoilBatten
TorFloor 2
TorFloor
Back
Suspended Floors
Suspended Floors
FoilBoard
TorFloor 2
TorFloor
Underplate
Back
Screeded Floors
Screeded Floors
ScreedPlate
Staple
Back
Acoustic Floors
Acoustic Floors
New Acoustic Range
TorFloor RdB
LowBoard RdB
FoilFloat RdB
Back
Low Build Up
Low Build Up
LowBoard
Ultimate 2
OMNIE-Tile
Back
Manifolds & Pipe
Manifolds & Pipe
Precision-Flo Manifold
OMNIFLO Pipe
FORMUFLO Pipe
Back
Back
Heat Pumps
Ventilation & Heat Recovery
Smart Controls & Thermostats
Hot & Cold Distribution
System Design
OMNIE for Developers
Technical Library
Technical Library
Datasheets & Guides
Install Videos
FAQs
Back
Case Studies
Get in touch
Book a RIBA CPD Course
About OMNIE
FAQs
Call us today 01392 36 36 05
Home | Resources
OMNIE HOME USB Coordinator
All

OMNIE HOME USB Coordinator

IG OHC 05

USB coordinator

Introduction

If you have no internet you can manually set up the system, this is done without the OMNIE Home app function.

USB coordinator connects the OMNIE Home devices in Offline mode and it is necessary to create a ZigBee network. USB coordinator provides wireless control of all devices in the OMNIE Home RF system. One USB coordinator can handle up to 30 thermostats, 8 wiring centres. If there are more than 32 battery powered devices in the OMNIE Home network (e.g. thermostats, relays) or distances between devices cause network range problems, the system must be equipped with an additional repeater, this can be any mains powered OMNIE Home device i.e. 230v thermostat or relay.


Stage 1

Attach USB Coordinator to a USB mains adapter or the USB point on the OMNIE Home wireless wiring centre.


Stage 2

Power up the USB plug or OMNIE Home wireless wiring centre.


stage 3

To commence system installation press and hold the button for 5 seconds until button starts flashing red. This means the ZigBee network is ready to accept RF OMNIE Home devices.

 


stage 4

When everything is paired press and hold button for 5 seconds or till the flashing stops. If you want to replace or add RF OMNIE Home devices please ensure you follow steps 3 to 4.


Checking system configuration

To check which devices of the RF Home system are paired and have been configured correctly, you can use Identify mode. Press the button to activate Identify mode. Using Identify mode the USB Coordinator will show all equipment that is connected to your system. Press the button again to cancel Identify process. Identify mode will time out after 10 minutes.


Factory Reset

Choosing a factory restore results in erasing all saved setting and removing connected equipment from the system. Press and hold button for 15 seconds, if you want to use a factory restore. When the process is completed, LED light will flash continuously.

PRODUCTS
  • Underfloor Heating
  • Network Controls
  • Heat Pumps
INFORMATION
  • About Us
  • Resources
  • FAQs & Support
  • Terms & conditions
  • Privacy & Cookie Policy
FOLLOW US
  • Twitter
  • Facebook
NEWS & UPDATES

© OMNIE