Hot & Cold Manifold Distribution
Simplify your hot & cold water distribution.
Hot & cold water that is distributed from a manifold improves installation time, reduces dependency on fittings and allows easy isolation of independent elements.
Key Benefits
Provides you with individual isolation of outlets and appliances if required. You are able to isolate parts of the system whilst the rest remains operational, reducing disruption for installation and maintenance.
Reduced installation time of between 30%-40% due to fewer fittings required.
Gives you a reduction of up to 70% of joints, with virtual elimination of tees and elbows, therefore the chance of leaks both during and post installation is greatly reduced.
Ensures that you have good accessibility in the event of a problem - limits the points at which a leak could occur to the point of use and the manifold, significantly reducing the time for fault finding.
All joints are above ground and are easily accessible.
Monoblocco connectors allow you to tailor the outlet sizes for different pipe sizes going to different outlets. You can therefore optimise the pipe size to be installed per outlet.
Allows you to adjust the flow rates to individual outlets.
Allows an easier understanding of water system schematics in relation to points of isolation. This will ensure future maintenance and repair can be carried out with minimum disruption.
Isolation and Maintenance
Manifold distribution provides total or individual isolation to all hot water and cold water points in the building, with the ability to isolate parts of the system whilst the rest remains operational therefore reducing disruption for installation and maintenance.
Manifolds can be installed in a convenient accessible location(s).
Distribution Manifolds
Nickel plated extruded brass manifold with colour coded isolating valves designed plumbing systems to minimise joints and leaks.
Available in ¾” single rails from 2 ways to 12 ways and can isolate individual circuits.
Can be mounted offset one above the other, side by side or upside down, using single or double mounting brackets or slider rail plug-in system.
Can be surface mounted, concealed in a purpose designed plastic cabinet or within a partition wall.
Red and blue outlet identification labels are supplied which can be marked to indicate which outlet they are serving for ease of maintenance.
The manifolds are supplied as single rails for flexibility in mounting and installation with a slider rail system, enabling the rails to be mounted either offset above one another or side by side.
Pipes are connected using monoblocco fittings.
Maximum operating pressure: 10 bar
Maximum operating temperature: 110 °C
Pre-insulated Pipe
The pipe comes fully insulated and colour coded (red for hot, blue for cold), this padding will also reduce the risk of noise from the water supply network.
Pipe routes can be planned in advance and once securely fastened in place they are basically maintenance free, no intermediate fittings to worry about, only fittings at either end which remain accessible with the pipe runs being fully insulated. The water is also protected against temperature loss for the hot and gain for the cold.
WRAS approved
Cross-linked polyethylene inner pipe (PE-Xb).
Bonding layer connecting the inner pipe to the aluminium pipe.
Butt-welded aluminium pipe, thickness min 0,2 mm.
Bonding layer connecting the outer pipe to the aluminium pipe.
Cross-linked polyethylene outer pipe (PE-Xb).
