ScreedPlate 11
Introduction |
---|
The ScreedPlate 11 panel has been purposely designed to avoid using fixings and staples in the floor and to speed up the installation of underfloor heating systems. The ScreedPlate 11 system consists of a series of interlocking panels with an integrated 10mm expanded polystyrene insulation (EPS) layer. The castellations in the panel provide grip for the pipe, whilst also providing protection from site traffic before and while the screed is being laid. ScreedPlate-11 can be installed over any sub-floor. Where floor build-up is limited the integrated 10mm EPS provides some resistance when the product is laid over an intermediate or ground bearing insulated floor. The panel is designed to allow pipes to be installed at spacing’s as close as 50mm and at 45° & 90° bends, providing additional flexibility. |
![]() |
Specification |
---|
OMNIE ScreedPlate-11 system using 16.5mm PE-RT pipe to DIN 4726 inserted into overlapping ScreedPlates with 10mm pre-bonded EPS. Expansion foam to be installed around the perimeter of the room. The system to be designed, installed and commissioned to BS1264. LAYFAST – Speed up installation time. This product uses our multidirectional pipe channel system. |
![]() |
Technical Details | ||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Panel Thickness Panel Dimensions Weight Pipe Centres Pipe Screed Existing Slab Heat Outputs
As a guide the heat outputs below are based on 16.5mm PE-RT pipe at 150mm centres with 65mm sand/cement screed laid over. Air Temperature = 20°C. (0.15 m²K/W = 1.5 TOG.) |
||||||||||||||||||||
|